![background image](http://html1.mh-extra.com/html/ecg/32fsl231/32fsl231_instruction-manual_3940681012.webp)
English
English
12
This option takes you directly to the source settings menu. Here you can change names, enable or disable
selected resources.
Inserting battery in the remote control
The battery compartment cover can be secured against accidental opening. To unlock, insert a blunt, pointed
object (e.g. a paper clip) into the hole above the cover and push it in. At the same time, slide the cover in the
direction indicated by the arrow. Insert two 1.5 V AAA batteries. Make sure the (+) and (-) markings match
(make sure the polarity is correct). Do not mix old and new batteries. Replace only with the same or equivalent
type. Put the cover back on and secure it again with the screw.
A message will appear on the display if the batteries are almost dead and need to be replaced. Note that if the
battery level is low, the performance of the remote control may be impaired.
Batteries must not be exposed to excessive heat, such as sunlight, fire, etc.
TV CONNECTION
Plugging into power
IMPORTANT:
The TV is designed for use with 220-240 V AC at 50 Hz.
After unpacking, allow the TV to reach room temperature before
plugging it in.
Plug one end (two-hole plug) of the supplied detachable power
cord into the power cord socket on the back of the TV as shown
above. Then plug the other end of the power cord into a power
outlet.
Note:
The position of the power cable input may vary depending
on the model. The position of the switch may vary depending
on the model.
Antenna connection
Connect the antenna or cable TV plug to the ANTENNA INPUT (ANT) jack or connect
the satellite to the SATELLITE INPUT (LNB) jack on the front side of the TV.
The back of the TV
1. Satellite
2. Antenna or cable
Warning:
To connect a device to the TV, make sure the TV and the device are
switched off before making any connection. Once the connection has been made,
you can switch on the units to use them.
Wireless LAN Transmitter Features
Frequencies range
Maximum output
power
2400 - 2483.5 MHz (CH1-CH13)
< 100 mW
5150 - 5250 MHz (CH36 - CH48)
< 200 mW
5250 - 5350 MHz (CH52 - CH64)
< 200 mW
5470 - 5725 MHz (CH100 - CH140)
< 200 mW
Restrictions by country
This instrument is intended for home and office use in all EU countries (and other countries using the relevant
EU guidelines). The 5.15 - 5.35 GHz band is restricted to indoor use in EU countries.
Landscape
Restrictions