Eccotemp CE-L5, Installation Use And Care Manual

Page: 13 / 39

13
EN
G
LIS
H
Support: Support.Eccotemp.com Shop Online: eu.Eccotemp.com Store Locator: eu.Eccotemp.com/locator
PLEASE NOTE: SH12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR THE MOST UP TO DATE WARRANTY AND MANUAL.
IN
ST
A
LL
AT
IO
N
•
illustration to the right).
• To conserve energy and to prevent freezing, insulate both cold and hot water
•
purposes. Before connecting the water supply pipe to the water heater, open the
•
the right. You’ll adjust this as needed seasonally to achieve desired temperatures.
If a water heater is installed in a closed water supply system, such as one having
inspector on how to control this situation.
CAUTION: This water heater must only be used with the following water supply system conditions:
• With clean, potable water free of corrosive chemicals, sand, dirt, or other contaminates.
• Free of lime and scale deposits.
• DO NOT reverse the hot and cold water connections. The water heater will not operate.
To ensure proper operation of the water heater, the following water pressure guidelines should
be followed:
•
and 1.89 LPM to maintain activation.
•
•
kPa) must be ensured. The
measurement should be calculated by the distance between the water inlet of the water heater (ground level)
• Well water systems should be set at a range of 50-60 psi(344-413 kPa).
• When the water is supplied from a water supply tank, the height of the tank and the diameter of the pipes
and their relation to water pressure, should be taken into consideration. Gravity water pressure is not
recommended.
NOTICE: Do not apply heat to the HOT or COLD water connections. Any heat applied to the water supply
NOTICE: If the water pressure resistance of a shower head is too high, the burner in the water heater will fail
to ignite. Keep the shower head clean from debris that could cause additional pressure drop.
overcoming hot water line pressure.
DO NOT use pipes with smaller diameters than the water supply connection of the water heater.
Be sure to connect the water inlet and the hot water outlet as shown on the water heater on page 12. If reversed,
the water heater will not function.
the water heater may disconnect easily for servicing if necessary.
plumbing materials and tools only.
Water Connections