English
POWER CORD:
• The electric power supply requirement for this water heater is 120 VAC/60HZ, 2 Amps.
• The water heater comes with a three (3) pin power supply cord. Use only a power outletv with a
ground terminal.
• The installation of an electric leakage breaker is recommended. (GFCI)
• Keep any excess of the power supply cord on the outside of the water heater.
•
If local codes require hardwiring, see instructions for “Hardwiring the Electrical Connections”.
WARNING: Shock hazard line voltage is
present. Before servicing the water heater, turn
off the electrical power to the water heater at
the main disconnect or circuit breaker. Failure to
do so could result in severe personal injury or
death.
CAUTION: Label all wires prior to
disconnection when servicing controls. Wiring
errors can cause improper and dangerous
operation. Verify correct operation after
servicing.
Electric Wiring Diagram
20HI Installation
Electrical Connections
