Page 2 of 16
1. Find an appropriate location for installation.
2. Drill holes according to the size of U-bracket and fix the U-bracket.
3. Drill a 3/4” (19mm) hole next to U-bracket.
4. Install the camera on U-bracket.
5. Connect the camera tail with the extension cable from inside the vehicle.
6. Loosen the hex head screws and adjust the camera’s position to get the best view angle in the monitor.
Figure 1
Wiring:
Important!
Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with
insulation tape. Wrap tape tightly, overlapping by one-half widths so there are no gaps.
Figure 2
AV1 input
AV2 input (V2)
Trigger Wire (Green) for AV2 only
GND (Black)
DC12V (Red)
Figure 4
Picture depicted is for reference only.
Picture depicted is for reference only.
Important!
Mount the camera at a location that provides the best view of the area immediately behind the vehicle.
Generally, mounting locations toward the top of the vehicle provide the best field of view. Lower mounting locations reduce
the field of view and increase the likelihood of damage from road spray.
Camera Model C2013B
Installation, Wiring and Function
Installation:
Figure 3
