14
1 5
P
P
P
P
1 5
P
P
P
P
,
(4)
How to DELETE all pin codes of all the users
In program mode, press
The letters P P P P represent the password,
You must press and hold the hash key # at the end of the command for three seconds until you hear the system
say:
“
The pin code was deleted
“
By SMS message:
To DELETE all pin codes of all the users by SMS command, send the following message:
(C) How to set the unit to FACTORY DEFUALT settings
There are two ways to set the units to factory settings, by the keypad or by SMS command.
1. By keypad
Enter **00*# and press and hold the # key for 3 seconds till you hear a long beep.
Enter **00*# once again (within 10 seconds) and the unit will respond with a long beep and announce
“Delete” after 10 seconds. If you do not enter **00*# the second time within 10 seconds, the unit will
disregard the command and exit that mode.
2. By SMS:
Send SMS command as follows:
PPPP**00*#,PPPP**00*#
The system will send back SMS message as:
PPPP**00*#, PPPP**00*# CONFIRMED.
©All Rights Reserved to
ECA Electronic Engineering Pty. LTD.
AUSTRALIA
Tel: +61 3 95720535
www.gatesonsolar.com
Warning !
Setting the unit to FACTORY DEFALT will delete all phone numbers,
pin-codes and set all the parameters of the unit to the factory Settings.
