12
P
P
P
P
C
C
C
C
N
U
U
U
P
P
P
P
C
C
C
C
U
U
U
13.
How to change the PASSWORD
The factory default password is 9999.
You can change the password in program mode as follows:
The letters P P P P represent the old password and the letters W W W W represent the new password.
The unit will confirm the new password by announcing:
“The number is ….”
By SMS Command
For changing the password by SMS command, send the following message:
The unit will reply by SMS:
The new password is X X X X
(B) Setting the Keypad Access Control
The keypad can store up to 999 different pin codes for up to 999 users.
The pin codes can be set for each user in
P
rogram
M
ode (
PM
).
1.
How to set the pin code for each user
You can program the pin codes via the keypad or by sending SMS command.
Via the keypad
a. Enter program mode.
b. The following letters and configuration represent the sequence for programming the pin code numbers:
-
The first three digits (
U U U
) represent the user number. From 001 to 999.
-
( N ) represents (1, 2 or 3 ) relay 1 or relay 2 or 3 for both relays to be linked to this user.
-
( *
C C C C
) the pin
c
ode number entered for this specific user.
-
(
#
)
Enter the information into the system.
The system will announce the pin code as a confirmation: “
The pin code is …”
Note: The system allows the same pin code for many users.
i.e., user No.1 and user No.8 can have the same pin code.
By SMS message:
-
The first four letters ( P P P P ) represent password.
-
( * UUU* ) represent the user number (from 001 to 999)
-
( N) represent Relay 1 or relay 2 or 3 for both relays to be linked to this user.
-
( *
C C C C #
) the pin
c
ode number entered for this specific user.
The unit will a send confirmation SMS to the sender
CONFIRMED
Or FAILED message as the
example
below:
FAILED
