User Manual
EC-CD-4617 Flip Top Cash Drawer
NOTICE
The manufacturer of the POS cash drawer makes no representations or warranties, either expressed or implied, by or with
respect to anything in this manual, and shall not be liable for any implied warranties of fitness for a particular purpose or for
any indirect, special or consequential damages. Information in this document is subject to change without notice and does
not represent a commitment on the part of the manufacturer.
INTRODUCTION
Industrial grade materials
Economical
Self-adjustable bill compartments
Small foot-print
Drawer open from any POS printer drive circuit which has RJ interface
Two-positions lock with unique key
Security –
no screws appear outside of the drawer
Slot for non-cash (Cheque) or large amount bill
Contemporary style
Accuracy mechanical parts with tight tolerance to assure wobble-free drawer movement
Fully compatible for other brands
Ready for OLE POS (OPOS) OCX driver
PACKING CONTENTS
1.
Cash Drawer, pre-assembled X 1
2.
Key X 2
3.
Bill dispenser divider X 4
4.
User manual X 1
INSTALLATION
The cash drawer has been pre-assembled to make the installation as simple as possible. Connect the drawer to the
POS printer as shown in Figure 1. Whenever the POS application software sends a drawer open command to the
POS printer, the printer will output a 12 to 24 voltage electrical pulse to open the drawer.
PROCEDURE
1.
Remove the cash drawer from the packing, then remove the keys and interface cable from the plastic bag.
2.
Connect the interface cable to the POS printer.
3.
Connect the other end of the interface cable to the “Control Signal Input” of the cash drawer.
4.
Insert the bill dispenser divider and bill clipper to the cash tray.
TEST COMMAND
The following test sequence will verify that the cash drawer is working properly. Before start this procedure, the cash
drawer must install correctly as outlined in the installation section.
POS Printer
Rear View
Interface
Cable
Figure 1
Cash Drawer
W
RJ Interface
