EC Line BT-8500, User Manual

Page: 11 / 80

8
ATTENTION:
It is important to know that the scanner will only
communicate with the cradle with the unique Bluetooth
MAC address. Other scanner cannot pair with that
cradle until the original connection is broken. If the
cradle pairs with another scanner, the cradle will
disconnect with the first scanner and then re-connect
with another scanner.
4.3 Setup SPP Slave Mode
Please follow the below steps to setup the
communication between the scanner and Bluetooth
application device.
1) The BT-8500 scanner must scan “SPP Slave
Mode” barcode, to set the BT-8500 scanner in
slave mode.
2) When control the Bluetooth device to search the
scanner, enter pin code (default 00:00:00) to
setup comport.
3) When BT-8500 scanner is successful connected,
the scanner blue LED will also blink with up-tone.
Blue LED will slowly flash to finish the setup.
4.4 Setup HID Slave Mode
To setup the communication between the BT-8500
scanner and Bluetooth HID profile application device,
follow the steps.
1) The BT-8500 scanner must scan “HID Slave
Mode” barcode to set the BT-8500 scanner in
HID slave mode.
2) When control the Bluetooth device to search the
scanner, enter pin code to setup pairing. You can
scan number barcode on Appendix A, “Decimal
Value Table” number 0~9, to setup.
3)
When BT-8500 scanner is successful connected,
scanner blue LED will also blink with up-tone.
Blue LED will slowly flash to finish the setup.