Chengdu Ebyte Electronic Technology Co,;Ltd
E880-IR01 user manual
Copyright ©2012–2019
,
Chengdu Ebyte Electronic Technology Co,;Ltd
33
Members:
It is used to set the number of hops (that is, the interface priority) and the proportion of each MWAN interface. The
member naming rule is generally: "interface name_hop number_weight ratio". As shown in the figure below.
The above defines four members, each with different hop counts and weight combinations, which provide services
for the subsequent strategies.
Strategies:
Used to group members and tell MWAN how to distribute rate of flow using this policy in “rules”. Members with
lower hops will be used first. Members with the same number of hops divide the flow proportionally according to the
weight. Members with a higher proportion of load balancing members will be allocated more flow. This device has 5
default strategies, as shown in the figure below.
The explanation is shown in the following table:
Name
Description
wan_only
Only use flow from the wired Ethernet interface
balanced
Use Flow from both Ethernet and 4G wireless interfaces and is obtained at a
ratio of 3: 2
4g_only
Only use flow from the 4G wireless interface
wan_1_4g_2
Wired priority, 4G backup
4g_1_wan_2
4G priority, wired backup
Rule:
It divides flow into specified "policies" based on IP addresses, protocols, and ports. Rules are
matched in order
from top to bottom. Except for the first rule that matches a communication, the other rules are ignored. Communication
that does not match any rules will be performed by the system default routing table.