Chengdu Ebyte Electronic Technology Co,;Ltd
E880-IR01 user manual
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co,;Ltd
17
In the basic settings, we enable the frp function and perform the following parameter correspondence:
For other options, select the default.
In the service-> Frp intranet penetration-> service list option (this option is at the bottom of the page), we click the
add button to go to the following interface and the setting interface as follows.
In this setting interface, we need to change the enabled state from disabled to enabled, and then set the relevant
parameters corresponding to the server, as shown in the following table.
Server parameter name
Client parameter name
Description
Tunnel protocol
Frp protocol type
http
Domain type
Select subdomain
Tunnel domain name
Subdomain
ebyte
Local port
Intranet host address
192.168.10.1
Intranet host port
80 (router web port)
Tunnel name
Service note name
test-ebyte-324717
Other selections default, and then click the Save and Apply button in the lower right corner.And restart the router.
After our intranet penetration function is successfully enabled, enter the Frp public network address in the browser,
as shown below. At this time, our management interface appears on the web page, indicating that our intranet penetration
start-up was successful.
Download source address
Software download source, select the default source
address -2
Server address
Server address
Fill in the obtained server address with this option
Server port
Port
7000
FRP authorization code Privilege token
Fill the server's authorization code into this option
