Ebyte E104-BT5032A, User Manual

Page: 15 / 42

Chengdu Ebyte Electronic Technology Co., Ltd E104-BT5032A User Manual
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co., Ltd
14
5. AT command
Note
：
keep module in wake-up mode before sending cooperation command.
5.1 Command instruction

There is no enter (\r) or LF(\n) required for AT command.

AT Command return info is ended with \r\n
（
except for return HEX
）

Command error response ERR=[NUM]
。 （
NUM is ACSII
）
5.2 Error code
NUM Description Error reason Solution
0 Currently parsing AT
Gap between two AT commands is too
small Proper delay is added between two
AT commands
1 Command does not exist AT command string is incorrect Check AT command character string
2 Incorrect parameter length
1
、
AT command length is incorrect
；
2
、
Length does not meet range
Check parameter
3 Invalid parameter 1 Parameter exceeds value range
Refer to command to check right
parameter
4 Air wakeup authentication failed Incorrect password
1
、
Use correct configuration
password
；
2
、
Reset password via UART
5
Current device role, this command
is not supported
This command is forbidden in
current role
6 Unknown mistake
7 Save parameter error
8
AT command exists, but operation
not supported
Refer to command and operate again
9 Disconnected Module is disconnected
10 MAC address does not exist Added MAC address exists already
11 MAC list is full
MAC address bond exceeds the
maximum numbers
Delete invalid MAC
，
add again
12 MAC address does not exist Deleted MAC does not exist
13 Connection failed
14
Exceeded the maximum number of
current connections
The current masters are all connected
1
、
Disconnect current devices
；
2
、
Modify maximum connection
numbers
；
15 Device does not exist
Error code list