PX100D_Manual_en-1.17.2i10
Page 27 / 59
7.3.2.1.
Activation mode and timing
Thanks to this option you may choose output operation mode. There are two
operation modes available:
o
Bistable- connection follows for indefinite time- up to the moment of
disconnection of power for module or remote command which switches
output off,
o
Monostable- connection follows for time defined by user - every 100ms.
7.3.2.2.
Conditions
Defines conditions for activating both of outputs. User can set following conditions:
No connection to server (immediately after detection);
No GSM signal (immediately after detection);
Detection of incoming call from defined telephone number;
Dependent on state transitions from non-active to active of one of the
inputs. Outputs can be also activated by internal watchdog, which can be
configured in “Link control” group.
7.3.2.3.
Additional conditions
If option “Dependent on state transitions from non-active to active of one of the
inputs” is chosen, we might configure additional conditions for output activations:
o
Never:
input disturbance does not cause operation of sabotage output,
o
No network:
input disturbance causes actuation of sabotage output if sending
of information to server is impossible.
o
Always:
every input disturbance causes actuation of sabotage output.