EBS Ink Jet Systeme GmbH
D-51588 Nümbrecht, Germany, Alte Ziegelei 19-25
++49 (0)2293/939-0
++49 (0)2293/939-3
e-mail: [email protected]
20
20140417#2.2
edited on 2014.04.17
19
Fig. 5.2.2
8.
At that moment the procedure for filling the iModule
®
starts, which is confirmed with the following message:
Filling iModule...
Transport protection
must be open !!
Please wait.
and with the blinking green LED above the
INK
ON
/
OFF
key on the operation panel.
9.
When the iModule
®
filling procedure is finished, ink starts jetting (the green LED above the
INK
ON
/
OFF
key on
the operation panel starts blinking), and when the printer reaches the
ready
state (the yellow
READY
LED
emits light continuously), you can start printing.
The ending of the iModule replacement procedure is indicated with the following message:
iModule replaced & accepted
Press ENTER...
and after it has been confirmed, the following message is displayed:
iModule
iModule accepted
Press ENTER...
Additional information about iModule
®
replacement:
All the
time while the
iModule
®
replacement procedure is being followed, the
message
iModule replacement in progress
is being displayed in the printer status window.
Any removal of the iModule
®
from the printer is indicated by short acoustic signals.
The replacing of the iModule
®
should take as little time as possible (a new iModule
®
should be installed
immediately the previous one has been removed) to prevent printer subassemblies (mainly switching-over
contact pins) from drying up.
After the new iModule
®
has been filled with ink, the time of ink flight in the head (displayed in the printer status
window) can exceed the permissible range for some time. A short-lived deterioration of print quality can also
occur. If the symptoms do not disappear within 1 to 2 hours, contact your service point.
If an attempt is made to install the iModule
®
whose use-by date (the
Shelf life
parameter) is exceeded,
the
iModule shelf life expired
message is displayed and the module is not accepted. A valid module shall be
used.
If
the
iModule
®
replacement procedure is interrupted (
e.g.
due to a power failure), it will re-continue after re-
start.
If the
iModule replacement aborted
message is displayed in the printer status window, this means that
the user did not agree to the installation of a new iModule
®
. In such a case it is impossible to start printing.
The iModule
®
replacement procedure should be restarted and followed to the end.
5.3.
Head Maintenance
5.3.1. Removing Head Cover
Before any operations are performed within the print head, remove the head cover first. Follow the steps given
below for this purpose:
1.
Uninstall the print head from the holder with which it is fixed in place.
2.
Screw out clamping screw
from the head cover – the screw cannot be screwed out completely, it can only
be loosened to its limit.
3.
Pull out the print head from its cover carefully
.
transport valve
transport valve closed:
in vertical position
and pushed in
transport valve open:
in
horizontal position
and protruding
