Installation instructions
ArgoDrive wheel change
AD-80.7
AD-100.12
AD-145.25
Article-Nr 14832 • 1.0 • en-us • Change • Release November 9, 2022 • page 6/11
ebm-papst St. Georgen GmbH & Co. KG • Hermann-Papst-Straße 1 • D-78112 St. Georgen
T49 (0) 7724 81-0 • Fax +49 (0) 7724 81-1309 • [email protected] • www.ebmpapst.com
8. Blocking the impeller using the bearing needle dia. 24.8.
9. Tighten the hexagon bolt ISO 4014 M8x40 supplied to 36
Nm ± 1 Nm with a WAF13 open-ended wrench.
10. Release wheel blockage by removing the bearing needle
dia. 4x24.8.
11. Remove the two M2.5x12 screws with an Allen wrench
WAF2 and check whether the two latches fall onto the slip
hub again.
Danger
Ensure brake function
If the two M2.5x12 screws have not been removed
and the two latches could not fall properly onto the slip
hub again, the brake is inoperative!
A brake test (see operating instructions) must
be performed before restarting.
