RON
EN
11
www.eberg.eu
3. DEVICE ASSEMBLY
Before starting the installation, carefully read the instructions and follow her tips. Keep this
manual for future reference
COMPONENTS
The components (parts) of the fan are shown in figure 1. After removing the device from the
packaging, check if any elements are missing. If it is missing, contact the seller.
ASSEMBLY
The only tool needed for assembly is a screwdriver.
1. Mounting the base
Insert the inner rod of the fan stand into the central hole in the round base, then from the bottom,
screw the rod to the fan base with a screw. Remember to use a steel washer.
2. Fan assembly
a) Slide the rear rotor cover over the motor shaft and fit the rear rotor cover to the motor assembly.
Then secure the rear rotor shield mounting nut.
b) Slide the rotor onto the motor shaft (axle) and tighten it with the rotor fixing nut.
c) Install the front cover. It should be connected to the rear cover with a clamping ring and a
locking screw.
DEVICE CONTROL
Before starting up, place the fan on a flat, even and hard surface and make sure that it is standing
firmly. Connect the power cord plug to the socket.
WARNING !
•
Do not plug the power cord into a wall outlet until the fan is completely assembled.
•
Use the power source in accordance with the electrical specifications on the nameplate.
•
Voltage: 220-240V ~ 50Hz Maximum Power: 55W.
