43
www.eberg.eu
RIO
PL
8. DECOMMISSIONING
E0
Communication faults between main
PCB and display PCB.
Check the wire harness of the display
PCB for damage.
E1
Ambient temperature sensor failure
Check connection or replace it. To clean
or replace the temperature sensor.
E2
Coil temperature sensor failures.
Check connection or replace it. To clean
or replace the temperature sensor.
Ft
Condensate water high level alarm.
Empty the drain pan by removal the
rubber plug.
8.1. STORAGE
Long-Term Storage - If you will not be using the unit for an extended period of time (more than
a few weeks) it is best to clean the unit and dry it out completely. Please store the unit per the
following steps:
1. Unplug the unit and remove exhaust hose and window kit store with the unit.
2. Drain the remaining water from the unit.
3. Clean the filter and let the filter dry completely in a shaded area.
4. Re-install the filter at its position.
5. The unit must be kept in upright position when in storage.
6. Preserving the machine in ventilating, dry, non- corrosive gas and safe place indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the unit is packed to avoid
component damage and molds. Unplug the unit and place it in a dry open area for days to dry it
out. Another way to dry the unit is turn on the machine, adjust it to low-wind ventilation mode,
and maintain this state until the drainage pipe becomes dry, so as to keep the inside of the body
in a dry state and prevent it from mildewing.
Releasing refrigerant into atmosphere is strictly forbidden!
8.2 DISPOSAL
This appliance may not be scrapped with domestic waste at the end of its life cycle.
We call your attention to the crucial role played by the consumer in the re-use,
recycling and other forms of recovery of such waste. The appliance must be scrapped
by a sorted waste disposal centre or by returning it to the retailer (no charge is levied
for this service), when you purchase a new equivalent appliance. Sorted disposal of
electric and electronic equipment prevents the negative effects on the environment
and human health resulting from improper scrapping, and also allows the materials
from which it is made to be recovered and recycled, with significant savings in terms
of energy and resources. The sorted disposal requirement is indicated by the crossed
waste bin label affixed to the appliance.
