Q1
GB
9
www.eberg.eu
REGULAR FUNCTION
FAN AND HEATING BY REMOTE CONTROL
TEMPERATURE CONTROL
FAN, HEATING AND OSCILLATION FUNCTION
Press the button to select one of the following mode
The default setting temperature is 23°C when the light °C is off
The heater working on full power when the room temperature is 4°C lower than the setting temperature.
1. Press the power to switch the ventilator on - the display will show Fig. 1.
2. Press the function button once to switch the heating on, on low power - the display will show Fig. 2.
3. Press the function button for the second time and the heating will switch to full power - the display will
show Fig.3.
4. Press the function button for the third time and the unit will return to mode 1 - the display will show
Fig. 1.
5. In each of the selected operating modes of the device, it is possible to activate the shutter oscillation
function - to do this, press the oscillation button on the remote control. To turn off the oscillation
function, press this button again.
Press again to switch off the appliance.
The device stops by going into standby (the fan stops 30 seconds after the stand-by).
1. Press the F button once - ventilator will switch on - the display will show Fig. 1.
2. Press the button again - the heating will switch on, on low power - the display will show Fig. 2.
3. Press the button third time - the heating will switch to full power - the display will show Fig. 3.
4. Press the button a fourth time-the oscillation function switches on - the display continues to show Fig.3.
5. Press the button a fifth time - the unit returns to standby (S). The unit will cool down for 30 seconds - the
display show Fig. 4.
Press to switch on the appliance.
- Press + or - to set the setting temperature from 10°C to 49°C
(the light °C is on). If room temperature
15°C, setting temperature 25°C, the display as the picture
Press to cancel the temperature setting (the light °C is off) and to choose the
heating on half power ( ) or full power ( ).
Fig. 1
Fig. 2
Fig. 3
Fig. 4