FOGI
GB
9
www.eberg.eu
HOW TO USE THE DEVICE
1. Locate an appropriate level flat surface near an electrical outlet for placement of your humidifier. When
placing on the floor do not place on shag or very high pile carpet or rug. Doing so may create an uneven
surface. Be sure to place your humidifier on a water-resistant surface and away from furniture and
electronics appliances since water can cause damage to furniture and other possessions. Position your
humidifier so that the electrical cord and the humidifier do not become a tripping hazard. To ensure
proper ventilation be sure to keep all sides and top of your humidifier at least 12 inches from walls or
any objects.
2. Remove the tank, turn the tank upside-down and remove the cap by turning counter-clockwise. Fill the
tank with cool water, for best results use distilled or filtered water. Do not use hot water or additives.
Replace the cap by turning clockwise; be sure not to over tighten. Turn the tank upright and position
the tank back on the housing. Be sure the tank is seated properly in the housing. Water will begin to
flow from the tank into the tray.
3. Connect to 220V 50/60Hz power supply after the tank injected water into the trough, touch the power
button, the LED screen light is on and humidifier starts to working. It will start at low mist output , mode
“1” showing on the LED screen.The ambient humidity is shown on the screen as well.
4. When the tank is empty and the water reaches a minimum level in the tray, the unit will automatically
shut down and stop producing moisture. The Refill light will be on and 3 beeps are heard. Turn off and
unplug the power cord. Refill the tank with cool water, for best results, use distilled or filtered water.
Do not use hot water or chemical additives. Properly replace the tank, plug into an outlet and turn the
humidifier ON. Comfortable, soothing, invisible cool mist will be produced immediately.
Obróć zbiornik
Odkręć
korek
Zakręć
korek
Zainstaluj zbiornik
z powrotem w
urządzeniu
