4 . 3
A u d i o C o n n e c t i o n s
4.3.1
SIG
N
AL CABLE
Use a good quality, 2-conductor shielded cable for all audio input and output connections.
4.3.2
I
N
PUT CO
NN
ECTIO
N
S
The four, female, XLR-type connectors labeled A through D are audio input connectors.
NOTES:
1. Select the signal type, analog or AES/EBU, in the hardware Utilities menu or
EAWPilot/UX8800 settings window.
2. XLR connector B is inactive when AES/EBU is selected for XLR connector A & B.
3. XLR connector D is inactive when AES/EBU is selected for XLR connector C & D.
Analog Pin-Out:
XLR A to XLR D
Electronically balanced, line level
Pin 1:
Shield
Pin 2:
+ (plus or high)
Pin 3:
- (minus or low)
AES/EBU Pin-Out:
XLR A and XLR C
Transformer isolated, balanced.
Pin 1:
Signal ground (shield)
Pin 2:
Channel 1
Pin 3:
Channel 2
4.3.3
OUTPUT CO
NN
ECTIO
N
S
The eight, male, XLR-type connectors labeled 1 through 8 are the audio output connectors.
Analog:
XLR 1 to XLR 8
Electronically balanced, line level.
Pin 1:
shield
Pin 2:
+ (plus or high)
Pin 3:
- (minus or low)
4 . 4
N e t w o r k C o n n e c t i o n s
4.4.1
ETHER
N
ET
The UX8800 communicates with a computer through its built-in, front panel, Ethernet port. This port is
configured as a standard NIC (network interface card). The UX8800 can be connected to an Ethernet
network using hub, switch, router, or wireless connections.
Cable:
8 conductor CAT-5 or better
Mating Connector:
RJ-45 male
Wiring Configuration:
Standard for connection to a network hub, switch, or router
Crossover type for direct connection to a computer’s NIC
Page 6
ETHERNET
ETHERNET
U-NET
1
2
2
1
ANALOG
PUSH
ANALOG/AES
ANALOG/AES
PUSH
PUSH
D
C
A
ANALOG
PUSH
B
1 Shield
2+
3-
2+
3-
2 Signal
1 Signal Earth
(cable shield)
3 Signal
1 Shield
OUTPUT (analog) INPUT (analog) INPUT (digital - AES/EBU)
