Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
5
MKC Series & MKD526
Bracket Instructions
NOTE: the outermost mounting point “A” is designed as an open slot to allow for easy locating of an
MKC Series or MKD526 Loudspeaker and loosely pre-installed hardware. If using the slotted mounting
point, the bracket must be installed oriented with the slot angled upward as visually shown in Figure 1,
opposing the ground.
c. Level - The back flange of the brackets must be level when installed to the mounting
surface for either figure 1 or 2 orientation and before installing an MKC Series or MKD526
loudspeaker to the bracket. Any geometric or structural modifications to the brackets or
hardware that are not EAW-approved will void the warranty and may result in damage,
injury, or death.
d. Mounting options
NOTE: It is recommended that you consult a building professional for the proper mounting
hardware before mounting the bracket. Due to various construction methods and materials,
the hardware for securing the bracket to the mounting surface is not supplied. It is required
that the use of hardware locking methods, not limited to lock washers, thread-locker, or
nylon-retention feature, be applied when securing the bracket to the mounting surface or
Figure 3 - Each bracket has multiple mounting hole options as shown above
One Ø5/8in (Ø15.9mm) hole (iii)
1. This hole can be used as a ceiling pole mount or a wall wire pass through.
2. If installing any bracket by this hole, a secondary safety point is suggested to be
secured.
Two inner Ø5/16in (Ø8.5mm) holes (ii)
1. These inner holes are spaced apart from each other on center and aligned.
2. These two inner holes may be used to install the bracket to a mounting surface
using load bearing hardware; both holes must be secured.
4. Installation of an MKC Series or MKD526 loudspeaker to a bracket.
a. Choosing a loudspeaker configuration
• Each bracket has an angle lock option.
• The mounting point is always connected using the M10 screw location on the top
and bottom of the loudspeaker (exception being MKD526 Yoke Bracket)
