Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
4
MKC Series & MKD526
Bracket Instructions
2. Bracket limits of use
a. The Brackets are designed to suspend
each corresponding MKC Series &
MKD526 loudspeaker with a design factor
designated on its appropriate bracket
label or exceed most global suspension
regulations. Maximum working load
limits of each bracket can be located on
its appropriately applied label. These
values have been confirmed with Finite
Element Analysis and destructive testing.
b. The weight/mass of each bracket is also listed on its appropriately applied label.
c. Each bracket are designed to suspend only one loudspeaker per bracket.
d. Any geometric or structural modifications to the bracket or hardware that is not EAW-
approved will void the warranty and may result in damage, injury, or death.
e.
WARNING: Take care when lifting MKC Series or MKD526 products to avoid harm or
damage to product.
f.
WARNING: MKC & MKD526 brackets are for suspension of loudspeakers only. Suspension
of persons is prohibited.
Figure 2 - Vertical Orientation.
May also be flipped 180° from
above image (Not applicable
with MKD526 Bracketry)
Figure 1 - Horizontal Configuration
3. Installation of the brackets to a mounting surface
a. Test fit a bracket on an MKC Series or MKD526
loudspeaker to confirm the correct angle, loudspeaker
and bracket orientation before installing the bracket
to the mounting surface.
b. Configurations - Depending on mounting option
used, the MKC Series U-Brackets may be installed
horizontal (back and arms are level/parallel to the
ground - figure 1) or vertical (back and arms are
plumb/perpendicular to the ground - figure 2).
MKD526 U-Brackets may only be used in a horizontal
orientation. If a vertical deployment is needed, the
Yoke bracket may be used.
