16
– CIS961 and CIS991
7. OPTIONAL KITS
Two kits are available for the loudspeaker. One is a
mounting kit, and one is a trim ring kit. Please contact your
dealer or EAW Commercial for ordering details.
AC-CK cable mounting kit
This kit consists of four 10-meter lengths of wire cable
with a crimped-on hook at one end. A small locking device
allows the length to be easily adjusted, so you can hang
the loudspeaker accurately in position in a suspended
ceiling, for leveling, or setting at an angle.
1. Find the location where you want the loudspeaker
to be suspended.
2. Use suitable flying points above the loudspeaker.
These may be ceiling beams or suitable eyebolt
hardware. (The dimensioned drawing at the bottom
of page 10 shows the location of the eyebolts.)
3. Pass the free end of each cable over the support
beam/structure and loop it through the hook/latch.
4. Pull on the free ends to take up the slack and thus
secure the hook/latch assemblies.
5.
Note:
The hexagonal locking
device has an arrow engraved on
one side. This must be pointing
down
when installing.
You will need an assistant to help
hold the loudspeaker in position
and support its weight.
Pass the free end of the cable through the outside
hole of the top end of a hexagonal locking device,
through a loudspeaker eyebolt, and back up
through the center hole of the locking device.
Fitting the hook/latch
to a support
Loudspeaker suspended
by four cables
Fitting the cable to an eyebolt
Close-up view of the
hexagonal locking
device
