Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
26
AC6
User Manual
Maximum Working Load Limit
Design Factor
10:1
7:1
5:1
AC6 flush mount
75lbs (333N)
107lbs (476N)
150lbs (667N)
b. The weight/mass is listed as the following: AC6 Flush Mount Bracket (10.3lbs, 4.7kg)
c. The AC6 Flush Mount bracket is designed to suspend only one loudspeaker per bracket.
d. Any geometric or structural modifications to the AC6 Flush Mount Bracket or hardware are not
EAW-approved will void the warranty and may result in damage, injury, or death.
e.
WARNING: Take care when lifting AC6 products to avoid harm or damage to product.
f.
WARNING: AC6 Flush Mount Brackets are for suspension of loudspeakers only. Suspension
of persons is prohibited.
3. Installation of AC6 flush mount bracket to surface
a. The wall bracket must be mounted to secure structure sufficient to support the products weight.
If you are unsure, please consult a qualified professional.
A minimum of two attachment points
must be used, each point capable of supporting 350lb (160kg) If four points are to be used,
each point can be rated at 175lb (80kg)
b. Mark the wall or structure where brackets will be mounted. Refer to the included customer
drawing (2071359-CD) for mounting pattern. Use the points that provide the highest amount of
vertical spacing.
c. If multiple columns are being mounted, spacing should be 39.0” (990.6mm) from centerline to
centerline. This can be measured from bracket top to bracket top.
d. Product is designed for vertical mounting only. Use of level is encouraged to ensure bracket is
vertical, and adjacent brackets align correctly when multiple speakers are mounted.
e. Ensure the bracket is in the correct orientation. The wall bracket can be installed in different
orientations to slide the cabinet bracket from the top or from either side.
f. Secure the bracket to the wall with minimum of two hardware points. Each point must be
capable of supporting 350 lbs. If four points are to be used, each point can be rated at 175 lbs.
Note: For mounting to wooden studs, two of the below points must be used depending on orientation
of the bracket. Install ¼” x 3”lg 18-8 SS lag screw or M6 x 80mm lg 18-8 SS lag screw with flat washers.
Mounting to metal studs is not recommend.
