14
Instruction Manual
Effective March 2020
eaton
www.eaton.com
2.3.4 Infrared light setting
This product can provide distinct images in environment with
illuminance less than 0.5LUX, the user can select the illuminance
of the infrared light according to the environment.
This operation can achieved by S2 in the infrared light cylinder.
Infrared light control module
On/off the
illuminance
setting of
the infrared
light
S2
Figure 2.3.4.1. Connection of the camera and control meth-
od setting
Figure 2. Figure 2.3.5.1 Infrared light control switch
The switch ON and OFF of every digit in the infrared light control
switch is in correspondence with power on and power off of the
corresponding illuminance switch. The infrared light start to work
when the environment illuminance is lower than the set value of
the swith; it will stop work when the environment illuminance is
better than the set value.
The default setting is the 3
rd
digit is set on. Only one digit in S2
can be set at on and the others must be off. Restart or remotely
reboot is required for the changed setting.
Table 3.2.5.2. Definition of S2
DIP
START-UP (LUX)
SHUT-DOWN (LUX)
1
0.5
4
2
1.5
8
3
5 (Default)
20
4
10
50
5
15
75
6
20
100
7
OFF
OFF
8
OFF
OFF
2.3.5 Inspection and examination before service
Check if the power supply, AB control cable and video cable are
well connected and if the settings on the switch are correct.
2.3.6 Service status and inspection in service
YHPTZ41 will start self checking automatically after power on.
•
Normal self checking procedures:
Rain wiper
run once
Horizontal left rotating a round→right
rotating a round
Vertical rotating to-90°→up to +90°→back
to horizontal position
2.3.7 Screen OSD display and menu setting
YHPTZ41 possess a perfect Chinese and English menu system:
via 95# preset position to callout the menu when the product is
stand by, the
up, down, left
and
right
button on the PTZ, also the
open
and
close
button on the iris become control keys. At this
time, command of the other keys are invalid, all settings in the
menu can be saved when power cut off suddenly.
2.3.8 Camera setting, IE browser and client software setting
See document provided by the manufacturer of the camera.
2.4 Support preparation before installation of YHPTZ41
2.4.1 Support type installation
Select suitable position for installation hole, adopt expansion
anchors to fix the support. The Ex junction box shall be installed in
a place convenient for installation and maintenance. Laying down
the cable from the slot or tray to the junction box.
See 2.4.1.2 for the support specifications.
Install support
Slot or tray
Ex junction box
wall
Figure 2.4.1.1 Support installation and wire connection
