13
Instruction Manual
Effective March 2020
eaton
www.eaton.com
2.3.3 Parameter setting
Protect the joint
Top cover
Set the communication
protocol, baud rate and
address here.
Figure 2.3.3.1. Parameter setting
Parameter setting method: use the special wrench to open the top
cover, set the communication protocol, baud rate and address by
using SW1, SW3, SW4, SW5, SW6 on the PCB.
Table 2.3.3.1. Definitions of SW1
SW1
Definitions
DIP 1~3
Model setting of RS-232 method controlled camera (see table 2.3.3.2)
DIP 5
PELCO_P/PELCO_D Protocol setting (see table 2.3.3.3)
DIP 6~7
Baud rate setting(see table 2.3.3.4)
DIP 8
Remote control switch(ON/OFF)
Function
setting
SW4
SW5
CPU RS485communication module
SW1
Address
setting
SW3
Figure 2.3.3.2 the main function switch arrangement on
the panel
2.3.3.1 Settings of SW1
Confirm the communication protocol and baud rate adopted by
the controller, then modify the settings according to the table as
below, at last restart or reboot remotely.
Figure 2.3.3.3 function switch SW1
•
Protocol setting
PELCO-P, PELCO-D, VICON protocols can be used. PELCO-P and
PELCO-D protocol can be set directly by SW1. For VICON protocol,
the following instructions shall be followed: turn on the 8th switch,
which means start remote control, restart or reboot remotely after
setting; then adjust the baud rate, protocol and address according
to the indication; use 95# preset bit to enter <control> menu and
<RS485>sub menu, set the protocol to VICON protocol.
Table 2.3.3.3. Protocol setting
Protocol
DIP 5
DIP 8
PELCO_P
ON
OFF
PELCO_D
OFF
OFF
VICON
—
ON
•
Baud rate setting
Table 2.3.3.4. Baud rate setting
Baud rate
DIP 6
DIP 7
2400 bps
OFF
OFF
4800 bps
ON
OFF
9600 bps
OFF
ON
19200 bps
ON
ON
2.3.3.2 Address setting (SW3, SW4, SW5)
Decimal encoding scheme is adopted in this product: hundred’s
digit(SW4), ten’s digit(SW5) and unit’s digit(SW3); address
range:0~255. The address is usually set on finished products, if
adjustment required, modify the settings then restart or reboot the
unit remotely to make the modification validate.
Eg. If the address of the explosion-proof integrated camera is 64:
set Sw4 at 0, SW5 at 6, SW3 at 4.
SW4 SW5 SW3
Figure 2.3.3.4 hundred’s digit(SW4), ten’s digit(SW5) and unit’s
digit(SW3)
