5. External connections
5.8 XV300 Touch Panel as a SmartWire-DT® coordinator
5.8 XV300 Touch Panel as a SmartWire-DT
®
coordinator
Applies only to XV-3.3-..-.E.-...-.. XV300 units with a SmartWire-DT® connection.
In addition to the information in this document, you will also need the information in the
following documents in order to set up a SmartWire-DT® network and install and oper-
ate it using the SmartWire-DT® master:
System description, engineering, installation, commissioning, and diagnostics for a
SWD network
SmartWire-DT® The System Manual
MN05006002Z
Setup, engineering, installation, etc. for the individual SWD modules
SmartWire-DT® Module Manual
MN05006002Z
Using the XSOFT-CODESYS-2 programming tool and the PLC runtime system for XV300
with Windows CE7.
User Manual
XSOFT-CODESYS 2, PLC programming XV300
MN048015ZU
5.8.1 SmartWire-DT
®
powered via POW/AUX
The POW/AUX- interface is not electrically isolated.
CAUTION
NON-GALVANICALLY-ISOLATED INTERFACES
The XV300 may be damaged by potential differences.
The GND terminals of all bus modules must be connected.
Do not connect the connector to the XV300 or disconnect it without first de-
energizing the system.
Electrical connection
Power supply SmartWire-DT®
POW/AUX
Figure 32: SmartWire-DT® power connector
XV300
12/15 MN048017 EN www.eaton.eu
59
