3. Installation
3.3 Mounting
3.3.2 Front mounting XH-303
Securing the panel with Holding bracket with set screw
List of tools:
l
2.0 m Allen key
l
PZ2 Pozidriv screwdriver
l
Torque wrench with Newton meter scale
The required holding brackets are included in the right amount as accessories with
the XH-303. All the included holding brackets need to be installed!
Together with the gasket, this holding bracket is the main element involved in achiev-
ing an IP65 (at front) degree of protection.
The purpose of the holding brackets is to secure the XH-303 onto a control panel, etc.
To this end, the brackets must be hooked into the enclosure sideways and screwed
against the control panel door, etc.
Position the brackets in such a way that they will press against the center of the one-
piece rolled gasket.
Pre-install the holding brackets using the set screws.
Check that the gasket is in its correct position and pre-install the holding brackets
One-piece rolled gasket along the edge
Foam rubber round cord, Material NBR/PVC black, closed outer skin, diameter 3 mm (0.12")
XH-303
09/22 MN048029EN Eaton.com
35
