Eaton TC 48, User Manual, Page: 22 / 56

Figure 2.3 Lead Termination
for TC 48 Figure 2.3 Lead Termination
for TC 48
7.0mm max.
3.2mm min.
6.0mm max.
3.0mm min.
1
2
3
4
5
6
7
8
9
13
12
11
14
15
16
17
18
19
20
90-250VAC
47-63 Hz
12VA 90-250VAC
47-63 Hz
12VA
L L
N N
OP1 OP1
_
+
OP2 OP2
_
+
ALM ALM
B B
B B
A A
RTD RTD
_
_
+
+
V V
_
+
PTA PTA
TC+, V+
PTB, mA+ TC+, V+
PTB, mA+
TC-, V-
PTB, mA- TC-, V-
PTB, mA-
TC TC VV mA mA RTD RTD
10
C C
NO NO
C C
NO NO
NC NC
C C
NO NO
Figure 2.4 Rear Terminal Connection
TC 96 Figure 2.4 Rear Terminal Connection
TC 96
Figure 2.2 Lead Termination for
TC 96 Figure 2.2 Lead Termination for
TC 96
50 C max. air ambient
Use copper conductors
(except on T/C input )
50 C max. air ambient
Use copper conductors
(except on T/C input )
CAT. I I
Unused control terminals should not be used as jumper points as
they may be internally connected, causing damage to the unit.
Verify that the ratings of the output devices and the inputs as
specified in Chapter 6 are not exceeded.
Except the thermocouple wiring, all wiring should use stranded
copper conductor with maximum gauge 18 AWG.
Unused control terminals should not be used as jumper points as
they may be internally connected, causing damage to the unit.
Verify that the ratings of the output devices and the inputs as
specified in Chapter 6 are not exceeded.
Except the thermocouple wiring, all wiring should use stranded
copper conductor with maximum gauge 18 AWG.
22
www.comoso.com