Eaton TC 48, User Manual

Page: 2 / 56

The Symbol calls attention to an operating procedure, practice, or the
like, which, if not correctly performed or adhered to, could result in
personal injury or damage to or destruction of part or all of the
product and system. Do not proceed beyond a warning symbol until
the indicated conditions are fully understood and met.
Installers
System Designer
Expert User
Read Chapter 1, 2
Read All Chapters
Read Page 12
NOTE: NOTE:
It is strongly recommended that a process should
incorporate a LIMIT CONTROL like L91 which will shut down
the equipment at a preset process condition in order to
preclude possible damage to products or system.
Some programming parameters shown in this manual may not
be available on currently offered models.
It is strongly recommended that a process should
incorporate a LIMIT CONTROL like L91 which will shut down
the equipment at a preset process condition in order to
preclude possible damage to products or system.
Some programming parameters shown in this manual may not
be available on currently offered models.
Information in this user's manual is subject to change without
Copyright September 2007 , Eaton Corporation, all rights reserved.
No part of this publication may be reproduced, transmitted,
transcribed or stored in a retrieval system, or translated into any
language in any form by any means without the written permission
of Eaton Corporation.
2
This manual is applicable for the products with software
version 23 and later version. This manual is applicable for the products with software
version 23 and later version.
www.comoso.com