Eaton TC 24, User Manual

Page: 19 / 54

Chapter 2 Installation Chapter 2 Installation
Dangerous voltages capable of causing death are
sometimes present in this instrument. Before installation or
beginning any cleaning or troubleshooting procedures the power
to all equipment must be switched off and isolated. Units
suspected of being faulty must be disconnected and removed to
a properly equipped workshop for testing and repair. Component
replacement and internal adjustments must be made by a
qualified maintenance person only. Dangerous voltages capable of causing death are
sometimes present in this instrument. Before installation or
beginning any cleaning or troubleshooting procedures the power
to all equipment must be switched off and isolated. Units
suspected of being faulty must be disconnected and removed to
a properly equipped workshop for testing and repair. Component
replacement and internal adjustments must be made by a
qualified maintenance person only.
Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas
should not exceed the maximum rating specified in Chapter 6. Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas
should not exceed the maximum rating specified in Chapter 6.
2-2 Mounting 2-2 Mounting
2-1 Unpacking 2-1 Unpacking
Upon receipt of the shipment remove the unit from the carton and
inspect the unit for shipping damage. If any damage due to transit,
report and claim with the carrier. Write down the model number,
serial number, and date code for future reference when
corresponding with our service center. The serial number (S/N) and
date code (D/C) are labeled on the box and the housing of control. Upon receipt of the shipment remove the unit from the carton and
inspect the unit for shipping damage. If any damage due to transit,
report and claim with the carrier. Write down the model number,
serial number, and date code for future reference when
corresponding with our service center. The serial number (S/N) and
date code (D/C) are labeled on the box and the housing of control.
Make panel cutout to dimension shown in Figure 2.1. Make panel cutout to dimension shown in Figure 2.1.
Remove stains from this instrument using a soft, dry cloth.
Don't use harsh chemicals, volatile solvent such as thinner or
strong detergents to clean the instrument in order to avoid
deformation or discoloration. Remove stains from this instrument using a soft, dry cloth.
Don't use harsh chemicals, volatile solvent such as thinner or
strong detergents to clean the instrument in order to avoid
deformation or discoloration.
This instrument is protected throughout by Double
Insulation . To minimize the possibility of fire or shock, do
not expose this instrument to rain or excessive moisture. This instrument is protected throughout by
. To minimize the possibility of fire or shock, do
not expose this instrument to rain or excessive moisture.
Double
Insulation
19
Remove both mounting clamps and insert the controller into
panel cutout. Reinstall the mounting clamps. Gently tighten
the screws in the clamp until the controller front panel is fitted
snugly in the cutout. Remove both mounting clamps and insert the controller into
panel cutout. Reinstall the mounting clamps. Gently tighten
the screws in the clamp until the controller front panel is fitted
snugly in the cutout.
www.comoso.com