XS series operating manual
XS user manual v0.55
- 105 -
Change of the board setup
IMPORTANT: the change of the board setup must be performed by skill people.
How to proceed:
Remove the power cord
Remove the screws securing the dark blue cover
Push the dark blue cover backward to access to the boards (remove the earth wire if
necessary)
Unscrew the board locking nut
Pull the board out
Set the jumpers as described here above
Plug the board
Lock the nut
Put the cover in its original position (with the earth connection)
Screw the cover
Connect the power cord
Put the power on
Operation
Go in the [SETUP] menu
Go in <page 2>
On the INTERFACE line, select the PLC mode (Programmable Logic Controller)
If the
[MISSING OPTION]
message is displayed, please check that the board has been correctly
installed.
Important
if the PLC mode is not selected, the Analog input-output function will not operate.
