2
Technical Data
TD150019EN
Effective January 2017
PXM4/6/8K Meter Advanced Color
Touchscreen Display Quick Start Guide
EATON www.eaton.com
4. Insert the PXM4/6/8K Meter Advanced Color Touchscreen Display
through the cutout. After the display is inserted into the front
side of the cutout, secure the display by attaching the 8 supplied
fasteners to the rear perimeter of the display.
Figure 4. PXM4/6/8K Display Fasteners.
5. Check for proper alignment of the PXM4/6/8K Meter Advanced
Color Touchscreen Display then torque fasteners to 7 lb-in.
(0.8 N
·
m).
Figure 5. PXM4/6/8K Display Fasteners - Installed.
6. Set the PXM4/6/8K meter to Advanced Display mode by chang-
ing the Security Mode Dip Switches to OFF-OFF-ON. This dis-
ables the log-in screen when the Advanced Display is connected
to the Local Config. Port. The Local Config. Port should never be
connected directly to a network.
Connections
To use the PXM4/6/8K Meter Advanced Color Touchscreen Display,
provide power through the included connector. This display accepts
an input from 9-36 VDC with a maximum power consumption of 60 W.
otee:
N
A power supply must be purchased as it is not supplied with the dis-
play. Eaton recommends the following power supplies: PSG60E (85-264 Vac
input); PSG60F (320-575 Vac input).
The display’s plug-in terminals provide connections for +V, -V, and
floating ground.
Figure 6. Power and COM Port Connections for the PXM4/6/8K
Meter Advanced Color Touchscreen Display.
The PXM 4/6/8K Meter Advanced Color Touchscreen Display requires
a shielded RJ45 Ethernet cable. This connects directly to the Local
Configuration CM1 on PXMCM-1.
Figure 7. Power Port Connection.
LAN 2
To CM1
(Local Config.
Port)
To DC Power Supply
Display Power Input Range:
9-36 VDC
Minimum 60 W
Security Mode Dip
Switches Configured
as OFF-OFF-ON
