Eaton POWERWARE Plus 18, Manual

Page: 132 / 311

Communications
81-84
85-88
89-92
93-96
105-108
109-112
OUTPUT VOLTS PHASE A This is the floating point average output phase volt-
age from the
The units on this value are volts. When displayed as volts,
there are digits all left of the decimal point.
OUTPUT VOLTS PHASE B This value is the same as the phase A value above
but measured on phase B .
OUTPUT VOLTS PHASE C This value is the same as the phase A value above
but measured on phase C.
This is the floating point ambient temperature
by the front panel. The units on this value are in degrees Celsius. When dis-
played as Celsius, there are three digits, one of which, is to the right of the
decimal point.
This is the floating point temperature
by the on this value in Celsius. When
played as degrees Celsius, there are three one of is to the right of the
decimal point.
SUPPLY TEMPERATURE This is the floating point power supply tem-
perature measured by the rectifier. The on this value are in Celsius.
When displayed as Celsius. there are digits, one of which, is to the
right of the decimal point.
from the The units on this value are amps. When displayed a9 amps, there
are two digits the decimal point.
LOAD CURRENT PHASE B value the same as the phase A value above
C This value is the same as the phase A value above
but measured C.
113-116
117-120
121-124
125-128
LOAD CURRENT PHASE CHART This is the 32 bit value for
the load current when it is at 100% of rated value. The units on this value are
amps. value has digits. It is used to display bar charts of the output
value above but for phase
A value above but for phase C.
OUTPUT BAR CHART This is the 32-bit value for the output KVA
when it is at 100% of its rated value. The units on this value are This
value has digits. It is to display bar of the output
6-35