Eaton Power XL DG1 Series, User Manual, Page: 21 / 44

DG1 Series Overview
PowerXL DG1 Series Option Cards
MN040007EN—April 2014 www.eaton.com
9
EMC Directive
For the electrical equipment installed in the EMC, directive
states that the equipment must not disturb the environment
and must be immune to other electromagnetic disturbances
in the environment.
Table 4 indicates the requirements for
the control wiring to meet this directive.
Table 4. Control Wiring Requirements
Control Cable Grounding
It is recommended that the shielded cables be grounded as
shown in
Figure 7 . Strip the cable insulation required
allowing attachment to the frame with the grounding clamp.
Figure 7. Control Cable Grounding
Option Card Introduction
Optional cards are connected to PowerXL DG1 control board
in two slots. For I/O cards, various inputs and outputs can be
used for control algorithms. Outputs also can be used for
status of the motor.
Table 5. I/O Card Input / Output
Item Directive
Product IEC 61800-2
Safety UL 508C, IEC / EN 61800-5-1
EMC (at default
settings) Immunity: EN / IEC 61800-3, 2nd environment
Radiated emissions: EN / IEC 61800-3 (Transient Testing
included), 1st environment
Conducted emissions: EN / IEC 61800-3
Category C1: is possible with external filter connected to
drive. Please consult factory
Category C2: with internal filter maximum of 10m motor
cable length
Category C3: with internal filter maximum of 50m motor
cable length
Board
Type Allowed
Slots
ID
Digital Input
(DI) Digital Output
(DO) Analog Input
(AI) (mA / V) Analog Output
(AO) (mA / V) PT100
Input
IO1 A, B 0x3012 3 3 — — —
IO2 A, B 0x3013 — — 1 2 —
IO3 A, B 0x3014 — 3 — — —
IO4 A, B 0x3015 — — — — 3
IO5 A, B 0x3016 6 — — — —