5
IL012287EN
Installation of PRLSEB type barrier kits
eaton
www.eaton.com
Step 3.
Installing the front barriers - (if applicable)
A. PD3
1. Line up the barrier's circular features with the terminal
holes on the breaker.
2. Press the barrier into place.
Figure 3. Installing the PD3 front barrier.
Step 4.
Completing the installation
A.
Fasten the large wire tie that was previously pre-installed at
the top of the boot.
B.
Install and fasten the small wire ties along the front of the
boot to close it.
C.
Cut off the excess wire tie material.
Figure 4. Installation of the boot - PD2 frames.
boot - PD3 frames.
Figure 5. Installation of the
Figure 6. Installation of the
Figure 7. Installation of the
boot - PD4 frames.
boot - PD5 frames.