Eaton Power Defense 32-NF, Instruction Leaflet

Page: 4 / 11

4
Instruction Leaflet IL0131080EN
Effective January 2019
3-way multi-family drawout cable interlock kit - type 32 - NF
EATON
www.eaton.com
Installation of two-way cable interlock
Required tools
•
10 mm hex socket
•
11/16-inch open-end wrench
•
3/8-inch open-end wrench
•
3/8-inch hex socket
•
2 mm Allen wrench
•
Drive extension
•
Adjustable wrench
•
Ratchet
•
Measuring instrument, in mm
Before proceeding with the following steps, ensure that all breakers
are in the OPEN and DISCHARGED position .
Step 1
Install the drive arm (D) to the end of the pole shaft using
one M3 x 8 mm flathead screw (C) as shown in Figure 4 and
Figure 5 . Apply LoctiteT Blue 242 to ensure that the screw cannot
loosen during operation . The drive arm should be oriented as shown
in Figure 4 and Figure 5 . Torque to 0,3–0,6 N·m (3–5 in-lb) .
Step 2
Install the trip pin
(F)
to the trip bar using an M3 x 8 mm flathead
screw (C) while holding the trip bar with an adjustable wrench
as shown in Figure 4 and Figure 5 . Apply Loctite Blue 242 to
ensure that the screw cannot loosen during operation . Torque to
0,3–0,6 N·m (3-5 in-lb) .
(F)
(D)
(C)
(C)
Figure 4. Details for Steps 1 and 2
Trip bar
Trip pin (F)
installed
Drive arm (D)
installed
Right side of breaker
Figure 5. Details for Steps 1 and 2
Step 3
Fasten interlock assembly (E) to drawout cassette’s right-side sheet
using three M6 x 12 mm hex bolts
(A)
and lock washers
(B)
as
shown in Figure 6 . Torque to 4,5–5,6 N·m (40–50 in-lb) . Ensure that
once the breaker is racked in, the interlock assembly trip paddle is
above the trip pin on the trip bar as shown in Figure 7 .
(E)
(A)
(B)
Figure 6. Details for Step 3