Page 3
Install the Fan
1. The position of the fan assembly is very important so as not to interfere with the
existing cabling or the CRT.
2. Place the monitor cover (1) top down with the sides standing vertically to the right and
left of the installer. (The cover is symmetrical.)
3. Position the fan assembly (2) inside the monitor cover against the right vertical side (3)
in the set of air slots closest to the top of the cover. The mounting screw holes of the
fan bracket (4) must be aligned in the third column (5) of air slots furthest away from
the installer. The fan must be oriented so it points away from the top of the cover.
(When in position, the fan will blow down into the center of the monitor.)
4. Use four #6-32 (6) screws and flat washers provided in the kit to secure the fan in
place by inserting the screw from the exterior of the cover into the captive nut
fasteners of the fan mounting bracket.
5. Make certain the fan mounting bracket is positioned up against the top of the monitor
cover before tightening the screws.
Reinstall the Cover
1. Connect the Fast-On connector for the black wire of the fan to the black wire of the
video cable.
2. Connect the Fast-On connector for the red wire of the fan to the brown wire of the
video cable.
3. Replace the cover on the monitor. Orient the cover so the fan is positioned directly
over the power switch. Make sure the cover slips inside the slots of the chassis frame.
4. Reinstall the six #6-32 screws to hold the cover in place.
1
2
3
4
6
5
