INSTALLING THE MODBUS CARD
EATON
Powerware
®
Modbus
®
Card User’s Guide
S
164201376 Rev C
www.powerware.com
4
Four-Wire Communication
The factory-default setting for the Modbus Card is for two-wire
communication. To change the default setting, adjust the jumpers on the
Modbus Card.
C A U T I O N
To prevent electrostatic discharge (ESD), place one hand on an unpainted metal surface such
as the UPS rear panel.
1.
If you are installing the Modbus Card into an X-Slot, complete
Step 3 only.
If you are installing the Powerware Expansion Chassis with your
UPS, complete Steps 2 through 4.
2.
Remove the card from the slot on the Powerware Expansion
Chassis rear panel. Retain the screws (see Figure 3).
Figure 3. Removing the Modbus Card
Summary of Contents for Network Adapter FCC 15
Page 1: ...Powerware Modbus Card User s Guide...
Page 31: ......
Page 32: ...164201376C 164201376 C...