Menvier300
Installation
Page 29
shows, for example:
The top line of the display shows the number
of new devices found. Because you have
restored factory defaults the control unit has
erased its internal list of bus devices and the
display will not show any devices as missing.
So, if a device is attached to the bus but not
powered up then the control unit will not
detect it. The bottom line of the display shows
the first in the list of found devices. Press
to see any other items in the list.
8. Press
.
The display shows:
9. Press
.
The
keypad sounder gives “deed ah”
confirmation tone and the display shows the
time and date, for example:
The control unit has saved all the changes
you have made.
Step 11. Commission the
System
Install Detectors and Other Peripherals
1. Use the Installer Menu to teach the system
the identity of any radio detectors or other
peripherals. (
Note that you must have a radio
expander already connected and installed on
the bus to do this.
) See the installation
instructions supplied with each detector or
peripheral.
2. Install detectors and peripherals at their
selected locations.
3. Use the
Installer Menu – Test
(see Chapter
5) option to:
a) carry out a walk test of the detectors.
b) test the operation of any other peripherals.
Program the System
Program the system to suit user requirements.
Page 30 is a summary of the Installer Menu on
the Menvier300. Please see the
Menvier40/100/300 Engineering Guide
for a more
detailed description.
Note: make sure that you allocate keypads
correctly to Wards. For more information see
“Assigning Wired Keypads to Wards” in the
Menvier40/100/300 Engineering Guide
.
Assemble and close the control unit:
a) Fit the lid of the control unit into the back of
the case (see Fig 50).
b) Fit and tighten the lid fixing screw.
NOTE: It is possible, for convenience, to place
links over tamper contacts to inhibit tamper alarm
during installation. Because of this feature make
sure you test all lid tampers before completing
installations, to ensure that no links are left fitted.
Figure 50 Replacing the control unit lid.
Leave the Installer Menu.
The red LEDs should go out, and the rim of
the navigation keys glow green. The system is
now ready to hand over to the user.
Handover to the User
Instruct the user on how to operate the system.
See the
Menvier40/100/300
Administrator’s
Guide
. If necessary, show them how to set the
time and date on the system.
Remember to leave the
Menvier40/100/300
Administrator’s Guide
with the user.
