Eaton
1121 Highway 74 South
Peachtree City, GA 30269
www.eaton.com/lighting
For service or technical assistance:
1-800-553-3879
Canada Sales
5925 McLaughlin Road
Mississauga, Ontario L5R 1B8
P: 905-501-3000
F: 905-501-3172
© 2019 Eaton
All Rights Reserved
Printed in USA
Publication No. IB503047EN
September 2019
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
Procuct availability, specifications, and
compliances are subject to change
without notice.
PoE Connection
PoE connection requires that IEEE 802.3af standard. Utilize a
network switch or PoE injector that meets this standard.
Connect the TSE80-B using a standard CAT5E or CAT6
Ethernet cable from the network switch to the LAN/PoE jack
on the back of the TSE80-B.
Connecting Ethernet
When not utilizing a PoE switch, it is recommended that you
connect the TSE80-B to a network switch via a PoE injector.
Utilizing a standard CAT5E or CAT6 network Ethernet cable
connect to the LAN/PoE jack.
Powering up the TSE80-B
Once connected to the power, TSE80-B can be set up via
DHCP of Static IP configured via the settings page.
Connecting to iLumin Plus
Ensure that the TSE80-B and the iLumin Plus accessory
TSI-1-NA are on the same physical Ethernet Network and
within the same IP address range. See the setup guide for
information on setting IP addresses.
Removing the TSE80-B
Using a precision Phillips head screw driver loosen the 2
captive screws on the underside of the TSE80-B. Lift the unit
upwards off the mounting frame hooks and then pull the unit
away from the mounting frame to disengage.
Loosen the 2 capative screws
before lifting off the unit
Specifications
Dimensions: 8.8” (223.5mm) W x 5.84” (148.3mm) H
Mounting depth: 0.86” (22mm)
Display: 8” (203.2mm Diagonal)
Resolution: 1280 x 800
Network: 10/100/1000 Ethernet
Connections: LAN/PoE RJ45
Power Requirements: PoE - IEEE 802.3af,
13W maximum draw (@48 V 270 mA max)
