Installing Battery Cabinets
3-6
EATON
Powerware
®
9390 Integrated Battery Cabinet (Models IBC-S and IBC-L) Installation Manual
S
164201536 Rev D
www.eaton.com/powerquality
7.
Install nylon grommet from field kit around hole left after removal of knockout
plug.
8.
Push the battery cabinet toward the UPS cabinet until the doors are flush with
each other.
9.
Secure the battery cabinet position by lowering the leveling feet until cabinet is
not resting on the casters. Ensure the cabinet is level and matches the height of
the installed UPS cabinet.
NOTE
Two cabinet joining brackets are provided in the field kit for securing each
cabinet at the top and bottom. A small flat bracket joins the top of the cabinets, and a
larger angle bracket joins the cabinets at the bottom. The small flat bracket is attached
to the cabinet tops first.
10.
Locate the small flat bracket from the field kit. Align the holes in the small flat
bracket over the two holes in the top front of the cabinets. Secure the bracket to
the cabinets with screws from the field kit (see Figure 3‐3).
11.
Locate the large angle bracket from the field kit. Place one end of the bracket
over the bolt on the bottom side of the lower left‐hand hinge on the UPS cabinet,
and secure the bracket to the hinge with hardware from the field kit (see
Figure 3‐4).
ÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒ
ÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒÒ
Top View
Ground Wire
Ground Studs
Bracket from Kit
Existing Hinge
Front of Battery Cabinet
Front of UPS Cabinet
Front View
Nut from Kit
Figure 3‐4. IBC-S Bottom Joining Brackets and Ground Wire
