34
Eaton 93PM Integrated Battery Cabinet (IBC-L, IBC-LH [432V], and IBC-LH [480V]) Installation Manual 164000228—Rev 08
3.
Locate the four 1/2" jacking bolts from the parts bag packed inside the front door and install them in the
threaded holes in the front and rear supports as shown in
. Place a floor protector from the parts
kit underneath each jacking bolt, and screw the bolts down against them.
The floor protectors protect the floor from being marred by the jacking bolts.
4.
Loosen, but do not remove, the skid mounting bolts holding the left, right, front, and rear to the pallet skids
(see
DO NOT
loosen or remove the cabinet mounting bolts or the cabinet support bolts.
5.
If a sidecar is installed to the IBC, loosen, but do not remove, the skid mounting bolts holding the pallet
skids to the sidecar front and rear supports.
WARNING
RISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become unbalanced. To
prevent tipping the cabinet, raise the cabinet no more than 3 mm (1/8") above the floor (just enough to allow the
removal of the pallet skids). Failure to follow these instructions can result in serious injury or death.
6.
Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately
3 mm (1/8").
NOTE
In the following step the center supports will drop away from the cabinet and the pallet
skids when the skids are removed.
7.
Remove the hardware loosened in
.
8.
If a sidecar is installed to the IBC, remove the hardware loosened in
.
9.
Pull the two pallet skids out from under the left, right, front, rear, and two center supports. Recycle the
pallet skids, supports, and hardware in a responsible manner.
Summary of Contents for IBC-L
Page 86: ...16400022808 164000228 08 ...
