Need help? Call
1-800-813-2199
for customer support or visit
www.homeheartbeat.com
If Your Water Sensor . . .
• will not respond, make sure the battery in the sensor is installed correctly.
• does not send a signal to the Base Station, move the sensor and Base Station closer together (or consider getting a Home Heartbeat Range Extender).
Set up
Test
Place and use
If you slide the Home Key into the sensor Slide Channel and the Home
Key screen shows either of the following messages, it means that the
Home Key or sensor may be outside the range of the Base Station.
If the Home Key or sensor is out of range, you can:
• Add a Home Heartbeat Range Extender between the Base Station
and Water Sensor, or
• select an alternate location for the Water Sensor, or
• try moving the Base Station to a more central location in your home.
Then, complete Step 1 again.
Water Sensor
CARRY
the sensor, battery, and the
Home Key to the location where you
want to place it.
OPEN
the sensor cover and insert
the battery. The green LED light inside
the sensor should flash four times if the
battery is good. Close the cover.
CLICK
the Home Key thumbwheel to
wake the screen, and
SLIDE
the Home
Key into the Slide Channel on the top
of the sensor. The Home Key screen
should say:
Please
w
ait…
De
v
ice found
OK to remo
v
e Ke
y
.
Follow the instructions on the Home Key screen to join the sensor
to the system, name it, and set
In-Home A
w
areness
and
"CallMe" A
w
areness
. After options are set and you click
Done,
g
o back?
, the Home Key screen will indicate that the
sensor is joined to the system. You may go to Step 2.
De
v
ice fou
nd
OK to remo
v
e Ke
y
...
PLACE
the sensor body on a vertical
surface that will not get wet, and
the water disc on a horizontal surface
where you expect water to pool.*
MOUNT
the parts by attaching the
enclosed adhesive tape to the back of
each or using #4 wood screws (not included).
* Be sure that the area of installation is clean and dry.
Remo
v
e Ke
y
...
Please tr
y
again
Sensor out of
r
an
g
e?
Remo
v
e Ke
y
...
Can't set up no
w
Ke
y
out of
r
an
g
e
ROLL OVER
and highlight
the Water Sensor icon
on the Home Key.
Test the sensor by dipping the water
disc into a cup of tap water—water must
touch both sensing elements at once.
Check the Home Key screen for feedback.*
* Water that is free of minerals or
sediment, such as bottled or distilled
water, will not activate the sensor.
Basement Floor
Dr
y
for 1sec
Basement Floor
W
et for 4mins