10
Alarm and Events Screen
4.3
The Alarm and Events screen displays time/date-stamped alarms (in red) and events
(in black) for all connected controllers. This information is stored in the HMI’s memory,
and will not be erased if the unit is powered down. Therefore, a “Reset History”
pushbutton is provided to clear all historical events and alarms if needed. A list of all
available messages is shown below.
Trend Screens
4.4
S1 Connected
S2 Connected
ATS Transferred
S1 Available
S2 Available
Load Sequence Active
Engine 1 Run
Engine 2 Run
ATS in Test
Transfer in Progress
ATS in Bypass
Monitor Mode
Go to Emergency
Emergency Inhibit
Go to Neutral
ALARMS
EVENTS
Slave In
Waiting for S2 Permit
Controller
Alarms
Controller
Events
In Lockout
Engine Test Aborted
Failed to Sync
Uncommanded Transfer
Closed Trans. S1->S2 Fail
Closed Trans. S2->S1 Fail
In-Phase Trans. S1->S2 Fail
In-Phase Trans. S2->S1 Fail
Open Trans. S1->S2 Fail
Open Trans. S2->S1 Fail
Generator 1 Unavailable
Generator 2 Unavailable
Mechanism Fault
Internal Controller Fault
Summary of Contents for HMIVU07CUNBE
Page 9: ...9 ...