Eaton Fuller FSO-2405, Service Manual

Page: 139 / 163

139
Front Section Disassembly
4
FSO-2405
2nd Ed. 02/07
Front Section
Mainshaft and Countershaft Rear Bearing Cups
Removal
1. Place the intermediate housing properly
supported with the bearing cup removing side
down.
2. Use the proper device along with the support
and remove the mainshaft and countershaft
rear bearing cups from the bearing bore.
NOTE: See “Special Tools”, Ref. E001035,
E001036. Used with E001037.
Installation
1. Support properly the intemediate housing with
bearing bore side up.
2. Prior to installing the bearing cup, carefully
clean both bearing bore and cup.
WARNING! Dirt between the bearing cup
and the bearing bore can lead to axial
clearance (end play) adjustment error.
3. Install the bearing cups without any shim
before adjusting the transmission end play.
WARNING! See topic “End Play
Adjustment”.
4. Along with the support, use the proper tool to
install the mainshaft and countershaft rear
bearing cups and drive the bearing cup into
the bearing bore until it is completely seated
on the bottom.
NOTE: See “Special Tools”, Ref. E001038,
E001039. Used with E001037.
3. Remove all the existing shims from the bearing
bore.
FSO-2405/173
2
FSO-2405/124
3
FSO-2405/174
4