![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operating-manual_524483066.webp)
LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
57
USB Flash Mode Submenu
The “USB Flash Mode Submenu” displays in the Settings menu when a USB device is detected in the USB
port. The menu selection does not display when the USB device is removed.
Figure 59. Example Settings USB Flash Mode Menu Display
Save User-Customized Settings Configuration Files to the USB
This LCD menu option allows you to save the user-customized configuration settings files to the USB drive.
These files contain your custom settings, such as network parameters, outlet names, and threshold values. If
you have several ePDUs of the same model and hardware configuration, you can copy the customized setting
files from one ePDU and upload the files to the rest of the ePDUs. This will help ensure consistency of the
settings and save set-up time.
After this procedure is completed, the following files will exist on the USB device:
l
eNMC/config/ConfigurationData.xml - Contains all network and communication-related settings. This can be
saved from and loaded to any ePDU G3 when replicating configurations regardless of part number.
l
eNMC/config/ConfigurationPdu.xml - Contains all the user-configurable settings related to the ePDU itself
such as voltage and current thresholds, customized naming, and outlet control parameters. The structure of
this file depends on the part number so that it cannot be duplicated from part number x to part number y
(PNx to PNy).
To save the user data configuration settings files to the USB drive:
1.
Make sure eNMC module is power ON.
2.
Insert a USB device in the USB port. Verify the USB drive contains the eNMC/config directory located at
root of USB drive.
3.
When the pop-up confirms that the USB is detected, click
OK
, and
then press
Enter
to return to the Main
Menu. (If not confirmed within 10 seconds, the pop-up goes away by itself.)
4.
Under Settings, select USB Flash Mode.
5.
The eNMC module restarts. (If there is no action within one minute, the eNMC module exits the USB
Flash mode. Remove and reinsert the USB drive to access this menu again.)
6.
Select Save Config (see Figure 60).
Daisy Chain
Settings
LCD
IPv4
Factory
Display
Language
ESC
Enter
Main Menu
Active Alarms
Alarms History
Meters
Control
ePDU Info
Main Menu
Settings
Enter
ESC
USB Flash Mode
Main Menu
Load Config.
Upgrade F/W
Save eNMC file
Load eNMC file
Exit
USB Flash Mode
Save Config.