![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operating-manual_524483067.webp)
LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
58
Figure 60. Example Save Config.
7.
Click
OK
to continue when a successful pop-up message displays the following see Figure 61):
l
The ConfigurationData.xml file is saved in the eNMC/ config directory on the USB drive.
l
The ConfigurationPdu.xml file is saved in the eNMC/ config directory on the USB drive.
Figure 61. Example USB Root with eNMC Config Directory
8.
Remove the USB drive and select
Exit
.
Load User-Customized Settings Configuration Files from the USB
This option loads the ConfigurationData.xml and ConfigurationPdu.xml files into the eNMC module from the
USB device. The new parameters in these files will be applied when the eNMC module exits USB Flash Mode.
When this option is selected, the eNMC module will first attempt to load the eNMC/config/
ConfigurationData.xml file from the USB device. Next, the eNMC module will attempt to load the eNMC/config/
ConfigurationPdu.xml file from the USB device.
1.
Verify that the USB drive contains the ConfigurationPdu.xml file and ConfigurationData.xml files in
eNMC/config directory of USB drive (see Figure 62).
Figure 62. Verify Files at USB Root
2.
Make sure eNMC module is powered ON.
3.
Insert a USB drive.
4.
When the pop-up confirms that the USB is detected, click
OK
then press
Enter
to go to the Main Menu.
(If not confirmed within 10 seconds, the pop-up goes away by itself.)
5.
Select USB Flash Mode from the Settings menu. The module restarts.
NOTE 1
The eNMC/config directory contains only these two files.
NOTE 2
The ConfigurationPdu.xml file is compatible with a specific ePDU part number.
Daisy Chain
Settings
LCD
IPv4
Factory
Display
Language
ESC
Enter
Main Menu
Active Alarms
Alarms History
Meters
Control
ePDU Info
Main Menu
Settings
Enter
ESC
USB Flash Mode
Main Menu
Load Config.
Upgrade F/W
Save eNMC file
Load eNMC file
Exit
USB Flash Mode
Save Config.