ELC-CODNETM
8 For more Information visit: www.eaton.com MN05006002E
To go online with the DeviceNet network, the computer must be connected to the ELC
controller which in turn is connected to the CODNETM module via the controller’s left-side
bus. In the DNET CONFIG software, select Setup, followed by Communication Setting, then
System Channel. The following screen will open:
These are the default communication parameters. Be sure to select the correct COM port
on your computer that is being used to connect to the ELC controller with the
ELC-CBPCELC3 programming cable. When the cable is connected and the interface
parameters are set, click the Network drop down menu and select Online and the following
screen will open:
In this case there is only one master communication module connected to the left-side bus
Summary of Contents for ELC-CODNETM
Page 1: ...ELC CODNETM Effective December 2010 Users Manual...
Page 2: ......
