Eaton DXRT 10KS31-IN Series, User Manual

Page: 93 / 98

92
Fault code: F305
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
rectifier fault.
Please contact your supplier
Fault code: A307
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
rectifier fuse fault.
Please contact your supplier
Fault code: F805
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
has detected
abnormally low
impedance placed on
its output and considers
it a short circuit
Remove all the loads. Turn off
the UPS.
Check if UPS output and loads
is short circuit.
Ensure short circuit is removed
before turning on again.
Fault code: F70D
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
get invert over voltage
fault
Remove some equipment from
the UPS, clear the fault code
and try restart again.
Fault code: F70C
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
get inverter under
voltage fault
Remove some equipment from
the UPS, clear the fault code
and try restart again.
Fault code: F704
Fault lamp lights long,
Beep continuous.
Indicates that the UPS
inverter fault
Please contact your supplier
Fault code: A80E
Fault LED is flash
2 beep every 1 second
Power requirements
exceed the UPS
capacity
Remove some of the
equipment from the UPS.
The UPS continues to operate,
but may switch to Bypass
mode or shut down if the load
increases.
The alarm resets when the
condition becomes inactive.
Fault code: A810
Fault LED is flash
2 beep every 1 second
Overload fault Remove some of the
equipment from the UPS.
Check if it is fault for the
equipment.