SOLID STATE COUNT INPUT
CURRENT SOURCING SENSOR
5 Enable/R
5 Enable/R
RST 4
IN A 3
IN B 2
GND 1
6 DC Common
7 +10-30VDC
BATTERY SAFETY
The lithium battery that powers your device contains inflam-
mable materials such as lithium organic solvent, and other
chemical ingredients. Explosion or fire may result if the
battery is not handled correctly. To avoid an accident follow
these guidelines:
*
Do not stack or jumble up batteries.
*
Do not heat batteries above 95°C.
*
Do not disassemble batteries.
*
Do not recharge lithium batteries.
*
Do not apply pressure to, or deform batteries.
*
Do not solder to batteries.
*
Do not dispose of batteries in fire.
*
Insert battery with correct polarity.
Terminal
1
2
3
4
5
6
7
Function
Ground
Input B
Count Input
Input A
Count Input
Reset
Reset Key
Enable
Backlight
Common
Backlight
Power
Operation
Use with Contact Closure to Ground
Maximum 20 Hz Count Speed
Use with Current Sourcing Sensor
Maximum 10 kHz Count Speed
Connect to Ground to Reset
Totalizer. This is a maintained or
Level Sensitive Reset
Connect to Ground to Enable
Reset Key
Connect to Power to Light Display
3
WIRING DIAGRAMS
CONTACT CLOSURE COUNT INPUT
FRONT PANEL RESET ENABLE & BACKLIGHT WIRING
5 Enable/R
5 Enable/R
RST 4
IN A 3
IN B 2
GND 1
6 DC Common
7 +10-30VDC
+
REMOTE RESET
5 Enable/R
5 Enable/R
RST 4
IN A 3
IN B 2
GND 1
6 DC Common
7 +10-30VDC
Current
Sinking
Sensor
+6 to +28 VDC
1.5ký
SOLID STATE INPUT
CURRENT SINKING SENSOR
5 Enable/R
5 Enable/R
RST 4
IN A 3
IN B 2
GND 1
6 DC Common
7 +10-30VDC
WIRING RECOMMENDATIONS
Following these suggestions will increase noise immunity
and extend the life of the product.
Cable: The connection between the count source and the
totalizer should be made with a two-conductor shielded
cable. The shield should be connected to earth ground at
one end only. The connecting cable should not be run in
conduits with cables switching high inductive loads.
Relay Coil Suppression: If a relay contact is used as a count
source, the relay coil should be suppressed. This can be
accomplished with an RC network for AC coils or a diode for
DC coils. The Durant RC suppressor (38091-400) may be
used.
Mounting: The totalizer should not be mounted near a
solenoid or other inductive devices. Enough ventilation
should be supplied to keep the totalizer operating within the
temperature specifications.
5 Enable/R
5 Enable/R
RST 4
IN A 3
IN B 2
GND 1
+
-
6 DC Common
7 +10-30VDC
